EF-10/20/40 MK II EndFedz® Antenna w/BNC female connector.
The original multi-band QRP (25 watts) EndFedz®. The Mark II version of the earlier EF-10/20/40 offers an inline choke which helps preventing it from being snagged in the trees when putting it up through branches or brush.
SPECIFICATIONS
Polarity: Depends on mounting configuration
Design Z: 50 Ohms
V.S.W.R. Bandwidth 40 meters: 140 kHz 2.0:1
V.S.W.R. Bandwidth 20 meters: 500 kHz 1.5:1
V.S.W.R. Bandwidth 10 meters 900 kHz 1.5:1
Power Handling: 25W CW/SSB
Weight: 0.5 lbs
Length: 41’
Hardware: Stainless Steel
Connector: BNC female
Radiator #18 black poly coated copper clad
The EF-10/20/40 may also be used on 20/30M by replacing the 40M tip with a 38” tip. This will raise 20 meter resonance a bit, but should not be a problem especially if 20 meters was initially set to the CW portion of the band or by connecting the stub to the choke end closest to the matchbox and reestablishing 20 meter resonance as desired. Alternatively, for 30 meter monoband use a 1/2 wavelength wire– begin with 46.5’ of wire.
Operation as a monobander on any band between 60 meters and 10 meters can be accomplished by removing the factory radiator and installing the appropriate 1/2 wavelength wire. Calculate the approximate length from L= 468/F(MHz). As an example a 25’ 10” wire will allow operation on 17 meters as a monobander. Initially, cut the wire a bit long and trim or fold back against itself for best V.S.W.R.
Need RG174U coax with BNC connectors installed ready to use? See the Par Endfedz accessories and coax page. Low prices!
Click here to read the operation manual.
