!
!

ACCESSORIES (Cables, dustcovers, and more)

!

3 wire cable - 1/4" connector

Model CP3.  4 ft. (120 cm) 3 wire cable to connect key to transceiver.  Stereo 1/4" plug to radio, spade lugs for key end.  Use for iambic paddles, Vibrokeyer.

3 wire cable XL - 1/4" connector

Model CP3/XL.  6 ft (180 cm) extra-long 3 wire cable to connect key to transceiver.  Stereo 1/4" plus to radio, spade lugs for key end.  Use for iambic paddles, Vibrokeyer.

3 wire cable - 3.5mm connector

Model CP3/3.5mm.  4 ft (120 cm) 3 wire cable to connect key to transceiver.  Stereo 3.5mm (1/8") plug to radio, spade lugs for key end.  Use for iambic paddles, Vibrokeyer.  Use for straight keys and bugs with one wire remaining disconnected.

3 wire cable XL - 3.5mm connector

Model CP3/3.5mm/XL.  6 ft (180 cm) extra-long 3 wire cable to connect key to transceiver.  Stereo 3.5m (1/8") plug to radio, spade lugs for key end.  Use for iambic paddles, Vibrokeyer.  Use for straight keys and bugs with one wire remaining disconnected.

2 wire cable - 1/4" connector

Model CP2.   wire cable to connect key to transceiver.   Mono 1/4" plug to radio, spade lugs for key end.  Use for straight keys and bugs.

Code Warrior Jr. 1/4" cable

Model CP3/CW.  3 wire cable for Code Warrior Jr. with 1/4" stereo plug on radio end and round terminal lugs as used on the bottom of the key for installation on the opposite end.

Code Warrior Jr. 3.5mm cable

Model CP3/3.5mm/CW. 3 wire cable for Code Warrior Jr. with 3.5mm (1/8") stereo plug on radio end and round terminal lugs as used on the bottom of key for installation on the opposite end.

Round Arm Vari-Speed accessory

The round arm Vari-Speed attaches to the arm of the bug in place instead of the weight(s), and the weight(s) are then attached to the arm to give the key a lower speed range at the low end - as little as 13 WPM.  See demonstration video!

Contact Burnishing Tool

Burnishing tool used to remove oxide and corrosion from contacts.  Safely clean Vibroplex silver contacts.  Thin strip 3" long x 0.25" wide. 

Code Practice Oscillator

CPO - Code Practice Oscillator.  Need to learn how to use a bug without the key connected to a radio?  Our CPO is ready to use.  Includes CPO board and speaker.  Add key cable and 9V battery.  700 Hz tone from LM386 audio chip @350 mW output power.  Not an electronic keyer - for use with bugs and straight keys only.